OKI X400 Instrukcja Użytkownika Strona 1

User’s Guide59309501X400

Loading Labels or Tags 1. Lift the top cover. 2. Press the two print head releases down to unlock the print head. 3. Unwind a few labels from

Loading Ribbon The OKIPOS X400 thermal transfer printer transfers ink from a ribbon to the label to produce an image. 1. Lift the top cover. 2.

13. Wait until the ERROR LED stops blinking and goes OFF; press the FEED button to feed a label or to resume printing. Spindle Notches Dull S

Selecting the Label Sensor Type OKIPOS X400 printers can use Eye-mark, gap or notch label sensing. The sensing method used by the printer must match

Using the Printer Printing a Self-Test Label Printing a self-test label checks the printer overall operability. To run a self-test, confirm that

Feeding Blank Labels To feed a label you press the FEED button if there is no image in the printer buffer. To clear the image buffer you must press

Note When holding the FEED button, the indicator status will change, but should be ignored even if the ERROR indicator becomes lit. Printing L

2. Using a soft cotton sheet moistened alcohol, clean all dirt and label residue from the print head, paying particular attention to the print line.

3. Press down firmly on both print head latches to confirm that they are closed. 4. Confirm that the printer ERROR indicator is off. 5. Print a

• Others: If you are using the serial communication check the parameters on both the printer and the host. Self-test label will not print 1. If

COPYRIGHT INFORMATIONCopyright © 2009 Oki Data Americas, Inc. All rights reserved.DOCUMENT INFORMATIONX400 User’s GuidePN 59309501Revision 1.2December

2. Confirm that the sensor type (Eye-mark or gap) in your software setup matches yours print media. Poor print quality 1. Confirm that the print

Printer Specifications OKIPOS X400 Print Method Thermal Transfer or Direct Thermal Max Ribbon Length 328 ft. (100m) Max Ribbon Roll OD 1.5 i

Memory 2MB total RAM; 2MB flash memory Bar Codes Sup- ported UPC, EAN8/13, EAN128, Code39, Code93, MSI, I25, M25, Postnet Bookland, Code 128, UC

Communication Ports OKIPOS X400 printers are equipped with a standard Centronics parallel and an RS232 communication port, wired as shown below. S

Parallel Input Cable (Centronics 36 pin) Pin # Description 1 STROBE 2~9 Data bits 0-7 10 ACK 11 Busy 12 PE (Paper End) 13 Select, always

Note OKIPOS X400 printers require a “null modem” cable (pin 2-3 and 7-8 cross connected) when connected to another DTE device such as a personal

printer model that will be used to print the label. Selecting “Printer Setup” opens a Printer Driver where the operating parameters of the printer can

TABLE OF CONTENTS What You Get ...3 Controls, Indicators, and Connections

OKIPOS X400 Software...23 Label Gallery Free...

What You Get The OKIPOS X400 Printers come complete and ready to install and print labels. Your unit carton contains the following items: • OKIPOS

Controls, Indicators, and Connections Device Name Primary Function Use Power Switch Power control Applies power to printer. FEED Button Ad

Print Head Release Unlocks print head Push both releases downward to release print head. Top Cover Protects print media and mecha- nism L

Printer Power Connection 1. Plug the output of the power module provided with the printer into the connector on the rear panel. 2. Plug the pow

7